Ford ABS Module Programming By Ford IDS

.
Here is easy step guide on how to reflash ABS module and program new ABS module for ford by VCM II IDS .Hop it is helpful.

Procedures of reflash ABS Module :

1 . Connect the VCM hardware to vehicle and launch Ford IDS software.

2 . Turn ignition key to "ON" position ,select 'Start New session' then All Other '




Wait progress bar complete ,and then click tick .






Select "None Of The Above" -->Select "Not equipped ",then it will show the vehicle specification ,click "YES"





Switch the toolbar ,and then select "Module Programming" >select ABS



And then software display below massage :

During Module Programming this module goes through a VIN verification process.

This process compares the VIN in this module with the VIN in other modules on the vehicule .You may see the VIN verification screen more than once depending upon your response to the question





Tab "Enter "the software display VIN :1F..................29 click "Yes or tab "Enter "to  continue .



Wait and the click "Yes"




Make sure your key is on and click Enter .





Then display the message :




ABS Module is Programming ,please wait .........




Set ignition switch to OFF (Position 0)




Operation in progress wait for complete .
Set the ignition switch to ON 
Calibration has been loaded and checked ,then tab "enter"




Switch the toolbar,and select --> "Self Test " > All CMDTCs" it will read the DTCs .





And then screen show as below ,select "U002B:08-08-RCM >Select "clear DTCs" >>select tick" to clear .Then wait for DTCs clear completing 




When the DTCs clear completing the ABS programming done .