How to use ECUsafe EGR/DPF/FAP Removal Software

This article show a guide on how to use ECUsafe EGR and DPF/FAP removal software.

How to use ECUsafe :



DOWNLOAD ECUsafe 2.0

1 - Run the ECUsafe software you will get below window : 

Information about licensed modules and database for DPF / FAP and speed limiters is presented.

2 - choose type of life  open combo box .

Standard selection is any car speed limiter only as seeking for speed limiter does not need file type to be selected .In other cases (DPF / FAP removal and ant obd protection )exact car and ECU (ECM) group should be chosen .In this example we choose VAG Siemens PPD.

3 - Select options -checkboxes on the right side .

Protection select to scan for DFP / FAP structures and change hem .

Use 2nd pass - use additional heuristic pass trough data if first pass was unsuccesseful .

4 - Select binary obe processed open binary button.

after opening binary (" Open binary ") Ecu binary")ECUsafe starts to process it .

This ay take quite a ong time ,especially when use 2nd pass  checkbox is checked .Progress will be visible on progress gauge.

In case of troubles you can switch off (by clicking appropriate button )some type of patches that may be applied by ECUsafe to your binary .When button is red that patch type wont be applied .Usually there is no need  to do this .In case of strange behavoir (no power at all  )try switching off .Torque limiters .IN case of too high Nox levels ,switch off "postinjection"removal .In case of diagnosis problems ,switch off "DTC errortable '.

Strategy Maps should be switched on anyway .

After ffinishing  processing of file Save binary button will be enabled .Pressing it will open dialog where file can be named and saved . Cancel scan can stop scanning at any time .

By pressing "online help " button this manual will be invoked in your browser if file is unsuccessully scanned and you want it to be manually processed by us ,and it's structures to be added to ECUsafe database press Upload file "this inovok web form ,where user should give his e-mail and description check for updates button invokes update for database it tries to get newer databases (if available) if it inds new database it shows popup windows with information about newer databases otherwise closes without ny popup.

While processing file comments will be visible:

Ecu software number it found 

structure that are found -here in this example PPD1.1L1 structure in DTC table responsible for particle filter pressure senor .

-after finishing of scan  information about success of failure of scan will be show .

 progress bar may go with various speed . when square indicator on the right of progress bar is gray checked empty  or unimportant area is found and scan goes faster if it is pale yellow data is found and scan goes slower successfully .Otherwise it is red.

5 - Opening EEPROM file .

ECUsafy can automatically process EEPROM file (red in programmer or extracted with BDM tool)

In cases when even after removing FAP /DPF there is blinking lamp at dashboard this means that level of FAP at moment of removal over critical point -vary from car manufacturer to car manufacturer - Usually it is over 200% this value is stored in EEPROM an,d must be cleared (sset below threhold - EEPROM editor is edded to ECUsafe .Read Eeprom and open binary file in ECUsafe 

Remember  to choose proper  brand of care and ECU type .point of Fap level stronge will be detected automatically .Set it to any low value (or zero) .Export file and program EEPROM with it .EEPROM checksum is calculated automatically .Blinking lamp will disappear .

Below you can see example of ECUsafe reaction to opening EEPROM file (notice that proper file type must be done .) Thise example is with Audi 3.0 TDI EDC16 EEPROM:

Usually you should set value to zero  .checksum in EEPROM is updated automatically.